Tips on homemade facemask from fabric with/without sewing

	Chinese faulty coronavirus medical supplies were rejected by European countries but acceptable to some Asean
	Vietnamese community in US collects gloves, face masks for local hospital
	Vietnamese traffic policer fines drivers by doing push-ups for not wearing face mask

Illustrative photo.

Depending on your method, you might need some or all of the following:

• Fabric

• Scissors

• Needle and thread

• Sewing machine (if you have one)

• Rubber band or elastics

• Ruler

Fabric

• The ideal fabric is tightly woven 100% cotton

• Try to avoid anything with too much stretch

• In a pinch, if you don't have cotton, you can use pillowcases, tea towels, thick T-shirts or vacuum bags

• Scarves and bandannas also work

How to make a mask with fabric without sewing:

1. Use a square scarf or a cut a large square out of a T-shirt (at least 20 inches by 20 inches).

2. Fold two sides of the square in to meet each other in the middle then fold this in half lengthwise. You should be left with a long rectangle with the edges sandwiched inside.

3. Grab two hair ties (or rubber bands) and pull one around each end of the long rectangle, roughly breaking the rectangle into thirds. (It should almost look like a candy wrapper.)

4. Fold each outside third of fabric into the center.

5. Pull the mask on by fitting the hair elastic around ears and making sure the end tails of fabric are against your face so the mask stays put.

How to make a face mask with fabric using needle and thread:

1. Cut two pieces of fabric that are equally sized (measure your face to see how wide/long you need them to be).

2. Take the two layers of your 100% cotton fabric or substitute. If you're working with patterns, face the two sides together (like you're making a sandwich).

3. Place the elastic or ties (*see instructions below) in between the layers and sew them into the corner. For elastics, sew one at each end so it creates a loop on each side. For ties, use one piece at each corner so there are four total.

4. Make three staggered pleats lengthwise on the mask, as if folding a paper fan. Then sew all the way around. This will make a rectangular mask.

How to make a face mask with fabric using a sewing machine:

1. Cut four pieces of fabric that are equally sized (measure your face to see how wide/long you need them to be).

2. Pair up two of the four pieces together so they are symmetrical. Sew the center seams (curved part that covers your nose) together. Repeat with the remaining two pieces.

3. Get your ties ready (*see instructions below). Take one tie from the 11-inch piece and one from the 9.5-inch piece. The longer piece will go on the top of the mask (where it would touch your nose) and the shorter will go on the bottom.

4. Place the two sewn pieces of fabric on top of each other (like a sandwich) so they're symmetrical. Place ties on the corners of one side of the mask. They should meet the edge of the mask and then go inside of the mask.

5. On the edge of the mask, you should see the following: one layer of mask, the ribbon/tie and another layer of mask. Sew the edges so they are all sewn together.

6. Next, repeat this step for the other side with your remaining ties, making sure to pair ties up so they're the same length and are symmetrical on both sides. Sew around the mask but keep one side open so you can turn the mask inside out.

7. Turn it inside out and sew the gap closed.